Originally Posted by Taurius
Hi everybody,
Ran my 8ight for the first time today and have a little question/issue about it.
The thing concerns rear inner pin plastic holders. After some practice for a couple for hours i noticed that it became deformed and unmounted from the alu plate at the end. Back ant home dissambled it and found out that the inner pinds pushed the ends of the plastic holder back, the pins (on both sides) were out about 2-3mm. Is it a common problem, should i ignore it or i pushed it a little bit too hard ?
Thank you
By the way - the clutch shoes already worned out
That sucks!! What are you running for clutch?