Hey guys, just bought this (MBX5-R):
http://www.rctech.net/forum/showthread.php?t=164882
Just a couple of setup related questions from the setup sheet:
1. Rebound stop, is this droop? If so, is it just a case of placing a wheel under the car and measuring how far the upright sits of the table?
2. Upper Arm position: Are the positions shown done using inserts?
3. What does E0106(A-D) refer to?
4. How is rear toe and anti squat set?
Also, what things should I be keeping a close eye on, other than the usual checking of threadlock etc. I've heard to ensure the servo saver gets a good clean and lube and to super glue the pillow balls? Things like that...
Thanks.