Originally Posted by minnesh
ok guys
this is it
i have had enough
loosened the belt
clearned all the bearings
fully charged a 4.2 battery
changed pinion to 38, 34, then back to 41,,,,,,, (oh spur is a 86 tooth)
and stll a ttoi (10 year old son) was on my back all the way
i dont under stand
the two cars have the same 540 motor( I even swapped the motor when the kid was gone for some food, that did not work...)
(very bad dad)
am i just wasting my time with a losi xxx s in a 540 motor class.......
however i have purchased a spur gear adaptor which is on the way (maybe if this will help at all i must say i really dont know now ....)
help.., help.., help.., help.., help.., help., sos., sos,.sos,.a
a newbie is distress help here.....
now can any of the losi gurus help me out here
do i just need to move to modified with a brushless
or what do i do here
sorry for the long post
thanks
mnnesh
if you swaped the motor and are sure its not the motor,
then it must be something you are over looking / have not relised.
are you running standard 63mm rubber tyres (diameter)
is it a tight or open large track?
have you double checked the end points on the controller then re set the esc setup?
have you tried the battery out of the tt01?
is the car or body scraping on the track?
what is the total rollout?
are the diffs too lose and slipping?
have you pulled out the motor & tryed the roll test to see if the car drive line is stiff or binding at all?
I will be able to work it out as my xxx-s is one of the fastest in 540 and i have been to heaps of clubs/tracks with very fast / experienced drivers that run high end cars, & my xxx-s is still up there with the fastest.