Originally posted by coolrcdad
I don't see a Dremel 9012 listed in the Dremel catalogue.
I used the #115 high speed cutter, 1/8 inch shank, 5/16 inch diameter to remove the chassis ribs. Here is a link to see it
http://www.dremel.com/html/images/pr.../large/115.gif
I used the #9012 carbide bit to make the slots for the battery straps, take out material from the sides for the turnbuckles and to enlarge the motor compartment hole. It can be found on the
Dremel website under the New Advantage Rotary Saw Bits. Here is a link to see it.
http://www.dremel.com/html/images/pr...large/9012.gif