R/C Tech Forums - View Single Post - Schumacher Corner
View Single Post
Old 03-06-2007, 07:40 AM
  #17648  
Kevin K
Tech Champion
iTrader: (32)
 
Kevin K's Avatar
 
Join Date: Aug 2001
Location: In a land of mini-mighty mental giants
Posts: 8,854
Trader Rating: 32 (100%+)
Default

Originally Posted by SpeedySST
Hi! I just installed the U2742 alloy pivot blocks in the rear of my Mi2EC and according to my setup tools, one wheel is at 3 deg toe in and the other is 2 deg toe in. Anyone know why? Thanks!
Make sure that the blocks are all squared up and that you dont have a bent pin. If when you tighten down the blocks they can move a little and that will give you a strange reading on the setup station. Just loosen everything and re-tighten it all back up and check it again....and check your hinge pins.
Kevin K is offline