Originally Posted by Scottrik
Are you using the Gen-X (Torpedo) tubes in the standard mount location on the MX2 and using the standard hardware for the tubes? if so, I think the "looseness" you describe is caused by the piston not being in as deeply as it is intended (causes a "wobble" at the end). The Torpedo tube assemblies are something like a quarter-inch shorter than the "standard" tubes. I am TRYING to finally get my torpedo tubes installed on my MX but I'm using longer hardware (the same DuBro 2-56 ball links for 4-40 rod I use for my tie rods) to get the pistons at the correct depth in the tubes.
Scottrik
Just an FYI, at some point late this summer, I'll be doing a new cross brace that will add a second set of holes closer together so that the new Gen-x style tubes will be able to be used with the chassis in their proper stock length.
Nice that everybody's sharing set-up info, I like to see it