R/C Tech Forums - View Single Post - Yokomo MR-4 TC Thread
View Single Post
Old 02-19-2007, 06:42 AM
  #2816  
Bikerbob
Tech Addict
iTrader: (11)
 
Bikerbob's Avatar
 
Join Date: Jan 2006
Location: Ontario, Canada
Posts: 544
Trader Rating: 11 (100%+)
Default

Well took my car racing on the weekend.. and it sucked.

I can set this car up for rubber.. and I can get it to run pretty good.

So far on carpet with foams.. crap.

I cannot dial out enough stearing.. I have my dual rate below 50.. I have stiff springs up front( going to try stiffer). Thing runs better with no compound on it at all. Hate not having droop screws.

I did still have the centre oneway in.. so I am taking that out. I was also told that my rear diff is much tighter than the front and the difference will cause the rear to get loose.. so i am rebuilding that.

This car is LIGHT as well.. at full trim I am 100grams shy of big race weight.

I think I need to get this thing balanced.. get the weight on it.. and then try again.

GOD this car need droop screws.. lol.. YES cant complain when I am the one deciding to run it.

That is my vote for best new innovation in RC.. not rebuilding your shocks, every race day.. and I do have to because the foams wear.
Bikerbob is offline