losi8ight,
Heres the link to A-mains outer hinge pins. I too have bent a few sets. I have three sets now. If one gets bent during a heat/race, I will swap it out in the pits. When I get home I use a small brass hammer and straiten them out again. I've straiten my original set 4-5 times now. It very easy to do....
I would like to see Losi chance the hinge pins to a bigger diameter (x2), but then they would have to change the rear arms and Hubs too to fit the new pins size. Just a though.......
http://www.amainhobbies.com/product_...oducts_id/7783