Originally Posted by kaotickc
Hey, been kinda watchin over this thread and soakin up as much info as possible, esp. from Ryan Barnes
. But still have not been able to cure my mid-exit corner push. Any ideas.
Im running a
2.3mm bar
1 small spacer in front of the upper arm
ackerman-middle
shocks- lower/outside hole upper 2nd out from inside
rear
3* toe block
shocks lower/outside hole upper 3rd out from inside
2.8 mm bar
Tracks I run at are small-med and normally hardpack and/or bluegroove. I just cant seem to get the car to stop pushing when on the gas out of a corner! Im fairly new to all this so bare with me if you can guys!
Thanks
"D"
1. Run the 2.5 toe in block in the rear.
2. And raise your ride height in the rear by 2mm (with the spacers)
3. Less droop in the Front. (don't let front arms droop that much)
Try this and I bet it will work.....