View Single Post
Old 11-14-2006, 11:16 AM   #14
Slapmaster6000
Tech Elite
 
Slapmaster6000's Avatar
 
Join Date: Sep 2004
Location: Edmonds, Wash.
Posts: 3,018
Trader Rating: 16 (100%+)
Default

I don't think that there is anything "more special" about this cavity tool other then it costs less and comes with two bits that do not require a power tool or pin vice to operate. ... and it's super easy to use. In the end, you get a hole centered in the brush. The others are good looking products too.


I haven't looked at doing a jig for round brushes yet. Sounds like I should.

Korey keeps "bumming" my prototype. He's been asking for the 1st one off the line for a couple of months. I can't watch him drive xacto blades into his fingers anymore
__________________
Stay dialed my friends!
www.slapmastertools.com
Team Roche USA
Team Orca orcharc.com
Slapmaster6000 is offline   Reply With Quote