View Single Post
Old 11-13-2006, 11:47 PM   #1
Slapmaster6000
Tech Elite
 
Slapmaster6000's Avatar
 
Join Date: Sep 2004
Location: Edmonds, Wash.
Posts: 3,021
Trader Rating: 16 (100%+)
Default Slapmaster Brush Cavity Tool

Something new from the Slapmaster Shop;

I have a new brush cavity tool coming out Dec 8th. If you like to use a cavity or a hole in the center of a brush to further tune your motors, this might just be the easiest tool to use and the least expensive on the market. The tool comes with two bits to work with: #53 (.0595") or 1.5mm and #49 (.073") or 1.85mm. The bits are finger operated, no power tools required. Simply lay the brush in the slot, hold it down with your thumb, select the bit size, insert it into the hole & twist away for a perfectly centered hole in the end of your brush. The pilot shaft on the bit fits into the brush jig without wearing out the jig. The brush tool is small so it will not take up valuable space in your pit box.

Availability should be around Dec 8, 2006.

I will be doing what I can to get it to some of my favorite retailers... so start bugging them now! They like that.

Brian Bodine
Slapmaster Tools
[email protected]
www.slapmastertools.com
Attached Thumbnails
Click image for larger version

Name:	P1010009.JPG
Views:	465
Size:	86.8 KB
ID:	181812   Click image for larger version

Name:	P1010013.JPG
Views:	602
Size:	72.9 KB
ID:	181813   Click image for larger version

Name:	P1010017.JPG
Views:	348
Size:	69.4 KB
ID:	181814   Click image for larger version

Name:	P1010022.JPG
Views:	478
Size:	73.4 KB
ID:	181815   Click image for larger version

Name:	P1010025.JPG
Views:	430
Size:	67.6 KB
ID:	181816  

__________________
Stay dialed my friends!
www.slapmastertools.com
Team Roche USA
Team Orca orcharc.com
Slapmaster6000 is offline   Reply With Quote