Jeff, here's the setup from RCR.
Front
shock position-tower:3
shock position-arm:2(furthest out)
upper arm position-bulkhead:1(top)
upper arm position-hub:1(closest to wheel)
tie-rod location-hub:2(furthest back)
oil:45wt.(schu)
spring:schu blue
piston:schu vari#3
length:66mm
droop:4 on hudy droop gauges
inboard toe:0
anti-roll bar:yes
castor:6
outboard toe:0
ride height:6mm
camber:-1
arm spacing:rear
diff(very tight)
Rear
shock position-tower:3
shock position-arm:2
upper arm position bulkhead:1
upper arm position-hub:1
oil:45wt. schu
spring:schu blue
piston:schu vari#3
length:66mm
droop:3
inboard toe:2(this could have been 0 as there was good bite)
anti-roll bar:yes
anti-squat:0
outboard toe:2
ride height:6mm
camber:-1
arm spacing:middle
take off 22's(pre-glued w/blue insert)
tire additive:none
stock schu carbon chassis/upper deck
servo:futaba 9450/expo:-10
body: protoform vauxhall
no additional weight added to the car