View Single Post
Old 01-10-2003, 08:49 PM   #5
rtypec
Tech Elite
 
rtypec's Avatar
 
Join Date: Jun 2002
Location: SoCal
Posts: 2,969
Trader Rating: 2 (100%+)
Default

Yeah Neil. So the bet is on! After TSR6 posts some early results we can see we sit. I spoke with the TRF guys today and it appears that DJ's roaching bevel gears in his Evo3 doh! But then again, extra flashing on one tooth would be considered stripped. Such a perfectionist.

As far as the Monster, cut the comm, align the brush hoods, and center the comm with shims. When you've done that try black springs on both sides, 4499's (no modifications) and start gearing at 7.6. The motor likes to wind out so don't be afraid to let it. If you need more top end, keep gearing up
rtypec is offline   Reply With Quote