Originally Posted by TryHard
Means if you drill a hole in your ball cup, you should never need to take them off the nut
HiH
Ed
And i had allready done this to me LCG (gone) & now my cyclone & evo 5
only yokomo have made use of this by pre drilling there off-road ballcups
but hotbodies even though they have the studs can`t be arse to drill the cup`s or tamiya
so much better this way ,every time you pop a ball cup it gets sloppier & more chewed up with your pliers
just drill hole or ream it so you can put hex drive straight in to undo & adjust
no start building mine yet
just cross referencing parts from evo 4 to evo 5, hubs, castor blocks are the same
don`t like the grub screw pinch for pin/castor block i preferr the screw pin that tamiya did