Thread: Ta04r...
View Single Post
Old 06-15-2006, 02:33 AM   #1948
Edgarski
Tech Adept
 
Join Date: Jul 2003
Posts: 224
Trader Rating: 10 (100%+)
Default

I used dean plugs too before.. flatten the end of the wire before you tin it with solder and solder to your battery, in that way the soldered part is not that bulky and it will still slide inside...now with regards to the wires, what I did was I made the red(+) long enough to reach the negative (-) terminal.. and than the black wire is very short like 1.5 inch long only..in this way you will only manage the red wire to fit with out touching anything like the belt... obviously your ESC dean plug will sit on th side where your batt's negative side is... this setup worked with my TA04R with no probs. I wish I still have old pics of my TA04R for you to see.

Quote:
Originally Posted by racenut
Is that what you did??? but i use deans plug in all of my batts is there a way i can retain my deans plug instead of bullet connector???
Edgarski is offline   Reply With Quote