no problem buddy.im going down to speedline next weekend if you guys wanna come.should be fun.
heres my set up guys.i will put in the number positions according to the setup sheet for tower locations and such.
cs27 premounts
Front:
1.5 camber
4 deg. castor
4.5mm ride height
6mm droop
spool
1.4 sway bar
.5 toe out per side
gold HPI springs
45 weight oil
1.5mm shims under the hinge pin blocks
tower shock position 2
arm hole shock position 1
bulkhead camber link location 4 3mm shim under the ball studs
acherman 2mm shim under both ballstud on steering rack
Rear:
1.5 deg. camber
5mm ride height
6mm droop
1.4 sway bar
3.0 rear block with 1.5mm shims
front hinge pin block shimmed up 3mm
hub camber link location 1 (no shims under ballstud)
bulkhead camber link location 4 w/ 1.5mm shims under ballstud
shock tower shock position 2
arm hole shock position 2
pink HPI springs
35 weight oil
wheelbase standard
front and rear width -.5mm
i ran a mazda 6 body,ran a CO27 with a 108 spur and 41 pinion.i used tire tweak and wiped the tweak off with buggy grip before i ran.this same setup worked great with a checkpoint 7x1.i geared that one at 108 spur and 30 pinion.