Originally Posted by SA_Racer
Has anyone here had problems with the VCS2 upgrade on their shocks? I did mine this week and it built like a dream. everything went together just like the instructions,
I did the oil, blader, big foam, small foam and then the top. Also put the stopper on the shaft between the balcup and the shock and all seemed to look good. tested dampening and everything was spot on, but then after my first run I noticed all the shocks were sticky at the top where the top screws on. so where did I go wrong. insturctions said I should remove the old rubber seal which I did and I cant see why they would leak, as the bladder is pushing right against the aloy body and that alone should cause a good seal.
thanks
any one hve the instruction i missed place mines to do the shocks