Thread: Hpi Pro 4
View Single Post
Old 08-13-2005, 08:18 PM  
josh69162
Tech Addict
 
josh69162's Avatar
 
Join Date: Jun 2004
Location: houston
Posts: 640
Trader Rating: 2 (100%+)
Send a message via AIM to josh69162
Default

Quote:
Originally Posted by AMGRacer
I had a MONSTER crash into a metal shelving unit at the end of the straight with an 8 turn and my rear arm took most of the impact. Did not break. Love this car.
Right here with ya...

Quote:
Originally Posted by aoizip
ran my pro4 first time(used).. it is as fast as my yok rayspeed...
thanks everyone to help me bullet proof my drive train..

now.. few more question coming from me again...
any hop up parts i should consider of getting..

i have most of the toe block, c-hub, spare cvds, arms, and diff..
what else should i stock up for this car beside the common stuff?

i was looking at the camber plate... will the plated one help also...

thanks for the help

~ming
I recommend the steering blocks. Most of the front end crash strains will be taken by the c-hubs and steering blocks. I had a nasty crash coming into the board at an angle. I snapped the steering block where the lower screw goes in and half the block was missing... And I also snapped the ball stud on the top for the camber link. I bent a hingpin so I would pick up some of those. They are like 5 bucks for two. I think that's it...
-Josh
josh69162 is offline   Reply With Quote