Originally Posted by Randy Caster
What I'd like to do, is on my QC2 just cut off the power switch, and use a single switch in my RX pack to control the power of everything, should this be ok?
My Reflex arrives tomorrow so I'm just trying to figure out how everything is going to go together.
I believe you are refering to the Quantum Competition 2. I have run receiver packs, 5 cells, with it a lot. I found I only had to connect the receiver pack to the receiver and use that switch to get proper function from the onboard radio system. I even tried a 2 cell LiPoly pack with the same configuration, but had servo trouble when using the Airtronics 94145 servo. I don't recommend the LiPoly battery unless you can drop the pack voltage into the 6 volt range. Good luck.