I'm new to TC racing and have a small issue with my FT TC4. When I'm corning right or left the inside rear tire is lifting off the ground and scrubbing corner speed. Car works great otherwise but is loosing corner speed. Actually almost sounds like the rubber tire cars in the corners. This is running on high grip asphalt on a large indoor track w/Foams. Any help would be great:
Setup Front:
Piston 2 - Oil 70wt - Spring Yellow
Shocks 2nd hole Top & Inside Bottom
Camber Link 2nd hole from inside
1st on Upright w/4Washers
Caster Block #4 - 4 Washers - Silver Ballstud
Droop 5 - Camber 2 - Toe 0
No Circle or Triangle Shims
Arm Spacing All 3 Shims Back
Anti-Roll Car .063 Silver
Diff - 4.5-5mm Ride Height
Setup Rear:
Piston 2 - Oil 60wt - Spring Copper
Toe 2.0 - Camber 2 - Droop 5
1 X Shim - 0 Square Shims
Arm Spacing All 3 Shims Forward
Camber Link 1st hole on both
Shock 3rd hole top - Outside bottom
LRP QC2 Punch 5, Initial 2, Auto 0
ROAR Stock Motor, 767's, Red/Green
Tires = Twister 37 shore 26mm front 30mm rear
Paragon GFX Traction Compound
Running on Asphalt:
http://www.rcscrewz.com/SpeedwayPhotos/CARPETRACK2.JPG
Hopefully I covered all the bases, if anything else is needed please let me know.
Thanks!