R/C Tech Forums - View Single Post - EAMotorsports discussion thread
View Single Post
Old 06-06-2005, 06:25 PM
  #2327  
TryHard
Tech Champion
iTrader: (4)
 
TryHard's Avatar
 
Join Date: Jun 2004
Location: Adelaide, Australia
Posts: 5,386
Trader Rating: 4 (100%+)
Default

Eric, another Q about shimming again... more new arms are coming my way (soon hopefully eh colin ).

I've been back over previous posts about it, but can't really figure it out properly... last time i tried it i compared it with a new monster i had, i think the ROAR arm took 2 0.2 and 1 0.1 shim onthe stack end to get it right! Well my interpritation of right at least... i'm thinking i might be slightly wrong there

Anyway, when you say let the arm centre, do you shim it so it remains centred, but allowing for a bit of down pull?


Btw tried a pair of the new F-lines you sent Colin this weekend, seems to me they are back to what they should have be 5 runs and the serrations are still there.... as is the power I'm pretty sure they are what allowed me to (finally) gear two teeth higher than a mate of mine .... rest of the day was rubbish though... 8th or so in the D.. and at my home track too. I'm rapidly thinking ashby is becoming my Bogey track

Regards
Ed
TryHard is offline