I wanted to give all of you a heads up and possibly get some feedback on our forthcoming Hyperform12 12th scale. It will be initially offered as a conversion but we should have a complete kit available by the end of the summer. All pieces will be cut from 2.5mm quasi-isotropic carbon fiber plate. This is four directional graphite and should prove to be the stiffest available. The kit will utilize damper tubes for dampening and the area outlined in green will be routed 1mm deep. This will allow for a lower rear roll center and cg. The chassis has the cells mounted as close as possible to the centerline without interfering with t-bar functionality and the chassis is also as narrow as possible for minimal rub. The front overhang is also shorter then most cars on the market to minimize rub. Cell position is adjustable of course.