So I converted my XV01 Pro to TC over the weekend. I had all the parts already to do it between my 419 and TA05 etc.
I'm a little baffled by something. The manual says that the TC version uses 44 mm drive shafts, which I installed on the CVDs. Problem is they barely sit inside the drive cup, unless you run a lot of camber.
Realistically 46mm would be more suitable.
I have been absent from this thread but I do recall one of you running the TC arms. Let me know what drive shafts your running
* I think I figured it out.. the TC comes with the front spool / direct drive. Those drive cups stick out further than the diff.
Last edited by Raman; 07-19-2017 at 11:19 PM.