View Single Post
Old 02-11-2017, 12:30 PM   #600
dumper
Tech Master
 
Join Date: Nov 2003
Location: CRC Raceway
Posts: 1,013
Trader Rating: 1 (100%+)
Default

Quote:
Originally Posted by BullFrog View Post
Brian when we talked at the birds you mention the roll center adjustment with motor shims. I did not ask if you were using them? For those out there could you also post your set-up for the F1 like you did for the WGT-R. Thanks for all the help at the birds- taking a week off before I try to improve my F1 results.
I use the gold motor screw washers under the carbon plate to help get the ride height. 1 per screw. It is .5mm thick, so if you have something else that will work too. My car has already been shipped to the next race, so i will post based on memory.
__________________
www.teamcrc.com, www.teamscreamracing.com, Outlaw RC Motorsports, KO Propo USA, www.crcraceway.com, Dumper's Speedshop, FB/FX Paint. 38.4mm>38mm, 9 degrees does not = Zero end of story. Vice-President of the F1 Pink Flame Posse
dumper is offline   Reply With Quote