I just built an XB2 CE '17 kit and had a few questions.
The driveshafts supplied are 67mm and the manual specs 68mm. The driveshaft pin looks dangerously close to coming out of the outdrive at full droop? Is this an update?
Also the included manual specs 400cst oil and 3 hole pistons in the rear shocks and the basic setup sheet for the 17 XB2 on Xray's website shows 350cst oil and 2x1.7 pistons. The kit came with 400cst oil and 2x1.7 pistons. Their online manual shows 400cst and 2x1.7 pistons. I build it with 400cst and 2x1.7. Any advice?