Hi all,
So I stopped by and saw my old buddies at The Gate Saturday and somehow left with a couple WGT chassis ready to be made into one GTR car. When I got home a read through this whole thread to get a feel for what I needed to make the car into a GTR ready racer.
So after some research on the CRC site I believe what I have is an WGT-LE with Gen X-10 front end mount plates (not sure why). So my question is with these mount plates I have three wheelbase holes instead of the two on the LE and SE cars. So which should I use? I know Dumper says to flip the LE plates and use the short holes but if I go short is that the same as the LE mounts short?
I am using shimmed stock rear pods and my wheelbase with the front arms in the full short holes is right at 9.875. Does that sounds about right?
Thank in advance!
Chris