Originally Posted by
offroader47
Hi guys,
I have stripped the screw head on the middle screw of the rear toe plate on my car, and was wondering what is the best way to get it back out?
Thanks
Use a Dremel with a cutting wheel to cut a slot in the center of the screw. Make sure the slot is deep enough and long enough to get a flat blade screw driver in it. Then spin it out with the flat blade screwdriver. If your cutting disk is a larger diameter, you may nick up the chassis a bit which is o.k., its just cosmetic. If you're really particular like me, I reduced the circumference of the cutting disk by running it against the stone wheel on my bench grinder. The reduced circumference on the cutting disk ensured the slot cut in to only the screw and not the chassis.