Originally Posted by
sakadachi
RCReggie- I'm sure you already probably know, but you can also play with thinner axle hex hubs and sand down the wheel hub side a bit on the inside to tuck the wheels in a little for added clearance.
I run the Monte Carlo (M01) body on one of my M05's. It runs fairly well, but it's a lot top heavier due to the scale decorations. I like it, but not really intended for racing.
Here is another M05 where I slammed the ride. This is the non-Monte Carlo M05 with its kit body. This is also running 55mm.
No, I actually didn't know - I'm just desiring to play it safe since I know the body I have is fitting 64mm tires fine. But I think I'll post that info to the youtube video of someone whom is having problems galore - trust me his isn't slammed down that far (in fact, I don't think mines quite that deep into the weeds either).
