Setup
Hey guys. New to the site but not to RC. Been doing it for 15+ yrs and working in the industry for the past 4. This is a setup question for those which the b6d running on high bite clay tracks.
How many if any are using the gullwing arms? Is anyone using the hard arms?
My setup was the flat arms and the lay down carpet trans until tnyt. I broke a arm and the track was out so I just put my gulling arms and tower back on and man I loved it!! So much turning. I could go so much harder into the corner than before. My question is what else should I change? Axle height or oil, spring weights? This is kinda a experiment since no one at my track is running them, well no one I know of anyway.