R/C Tech Forums - View Single Post - RSD RR12 12th Scale Pan Car Kit
View Single Post
Old 11-06-2016, 06:20 AM
  #582  
landau
Tech Apprentice
 
landau's Avatar
 
Join Date: Jun 2005
Location: Tx/Tokyo
Posts: 68
Default

The 2016 Winter On-road Series at the Banana!
Classes:
17.5 12th Scale
USGT
17.5 Sedan
Mod Sedan
25.5 F1
Nas class

Dates:
November 5th
November 12th
November 19th
November 26th
December 3rd
December 10th
December 17th

I attended 1st race yesterday 17.5/12th.
RR12T2 was pretty nice performance.
This car, I thought, is not neccesally rubber tyre, such as BSR controlled.
Tyre wear was flat also. I could use same tyre 5 packs(P1+Q3F1) from F41.0mm R41.5 to F40.3mm R40.9mm. After race, tyre surface keep flat.
Wheel: Yokomo/ Yellow

Cristian's Innovation, motor cooling fun, had well performance. Motor Temp approximately same each round, 43.4-44.3Centigrade.

I have never tested BSR tyre so far, but comparing CRC lilac, form tyre is not bad. Forward traction on form tyre was better than rubber. Steering was little bit nasty; first 2mini requires careful drive, last 2mini less initial response.

The only bad is upper arm. I have used Asso arm. This arm should exchange routinely.
Xenon is better, like as Cristian's T2.

Overall, I felt T2 had little bit advantage compare with others.



ESC: Tekin RS
Battery: Reedy6500(dead during race) or Trion7000(over 200 packs), I have to buy new one.
Motor: TS V3
ratio: 53/76
ride hight: 3.2mm
Steering pretention: 0.8mm(at first, 4mm ride hight with free droop screw, and then adjust 3.2mm)
caster: 1.5/Right, 2.5/Left
camber: R0.3-0.5 L0.5-0.7 (F.E. Q1=R0.5L0.7,,,Q3 or Final=R0.3L0.5)
landau is offline