Originally Posted by
thecman26
B5,B5M, & B4.2 manual says which side to put it on. I am pretty sure they were designed to be places on a specific side, too bad there's no AE design team support on here. I am sure every other AE manual I have seen also says which side it should be on. But neither here nor there... I haven't decided to go rogue and test out what would happen if I was a rebel and put it on the other side...
Since it's the new 'ball cup' topic...
B4 manual says screw head on the spur gear side.
b4.1/t4.1 manuals don't say which side to put the head of the diff screw.
SC10FT manual doesn't say which side...
SC10.2 manual says spur gear side...
Originally Posted by
kdub
I think I count as an authority on the matter. I always run my diff screw on the right side (when sitting "inside" the car). I take off the tire and pull the outer hinge pin to get to the adjustment screw.
The right rear is the way the AE manuals state (or used to state). It really shouldn't matter since you go around turns both left and right.
Thank you..?