Horizontal stress
The other day, my local track did an outdoor race at an RC Airshow at a small airport. They rolled out the turf, put down some plastic jumps and tubing to create the track. This was laid over pavement. So, I ran my freshly built B6 during warmups and I had to call it quits when the screws on the bottom that hold everything in the rear in all backed out. Guy there said it was caused by the horizontal stress. The track was so grippy, there was almost no sliding at all.
My question is, how would I prevent this? Keep in mind everything is stock so far. I got the aluminum d mount and a chassis protector. Haven't had time to rebuild yet.
Thanks