The below is for a different buggy, but checkout all the settings for the bushings. It's easier to understand by looking at what the bushing placements do to toe and anti squat
http://site.petitrc.com/setup/xray/s...2_SetupHelper/
Originally Posted by
onefast8
Hey guys, need some help with a few settings on my b6d laydown.
I just finished building my b6d (ill spare you the unimpressive pics) and I'm trying to decide if I want to get new alum. rear hubs or use my B5m single axle height Schelle rear hubs.
What is this adjustment really doing? Is this a well used adjustment? Is it the same as +/- a shim under the outer ballstud? Also, is this a necessary change for raising or lowering the inner hinge pin height?
On that note I am trying to run a wide inner pivot with 2.5 tow in and 1 anti squat. So as far as I can tell I need center 1's facing out in C and center .5's facing out in D? Not sure here still kinda confused on the whole pill insert thing.
Appreciate any input!