Originally Posted by
BigChris in PA
Fitment issues:
1) I studied and triple checked the orientation of the steering rack. I'm 95% sure I've got his right. Bag 1 Step 1 wants a 2mm spacer under the ballstud on the bell crank. I installed them and then ultimately removed them b/c I am not stoked with the amount of steering "throw" The ball stud/ball cup crashes into part 91667. If I compare the steering throw of my B5M FL to the B6 side by side, the B5M has got tons more. See the pic below. Maybe I'm doing something wrong, please advise.
pay close attention to the orientation of the rack. If its upside down or backwards then the ball stud could hit the bellcrank. With it properly there is no way with 2mm of spacing. You can email me a pic if you have other questions. Check your pm.
Last edited by Matt Trimmings; 08-17-2016 at 06:29 AM.