Originally Posted by
oPAULo
After spending hours to get it to spin free, it lasted less than 2 runs. I had my doubts about 3D printed parts. I'm sure others have had better results with the stuff. I'm just sharing my experience. I hope there's gear cases on that KYO boat.
My 3D Printed gearbox also didn't last at all. Screws stripped upon install. More screws falling out after some very light use. No RC part should be made with SLA 3D printing. You don't want layers.
I bought my setup from Jason M on facebook, and he was nice and helpful however I'd never buy another one like this.
Really hope there are gear cases on the boat too. Right now my RB6 needs me to re-hack the old rear motor setup...for 3 gear.