Originally Posted by
Slapjack
I am thinking maybe this can be fixed thru the hotwire settings but I could use a little help. I just finished my new EB48.3 last night. I took my RX8 Gen 2 and motor out of my ET48 and swapped the whole thing right over and bolted it into the EB. When I turned it on the car drives forward when I hit reverse on the controller and it brakes when I pull the trigger. Then it will reverse when I pull the trigger. I tried reversing the throttle in the radio but that didn't work. It was working fine in the ET48 and I didn't disconnect anything. I used the same receiver and everything just swapped it all over to the buggy. Is there a setting in the hotwire that can change this? Do I have to reverse the direction of the motor or something?
It's been a while since I built mine but is it possible you have the front and rear diffs in backwards?