Yes everyone at the track runs the same tires. Surface is clay/dirt outdoor, bumpy, very dusty in the corners off the main line. Track sometimes turns to blue groove, but not often. We wet the track but drys out pretty good after 3-4 heats. Gets pretty rough on big event days.
Battery is mounted in the rear. 4500 Team Orion shorty pack mounted width wise.
Rear toe in is 3 degrees, Front is 0.
Camber set at -1 Front and Rear
Yes I have the adjustable alum rear suspension mounts.
Rear toe in is: In-C AND In-C (3.0 Degree)
Front camber links:
- Outside has 1mm shim
- Inside is mounted in middle position of 3 with 2mm shim
Rear camber links:
- Outside rear hole with 2mm shim
- Inside link mounted on outside hole with 2mm shim
- Hub spacing is spaced towards the rear ( 3mm shim in front of hub )
Front Shocks
- Outside on tower, inside on lower arm
- Pink springs
- Long ball end type on shock
Rear shocks
- Upper tower 2nd hole from outside (#3 hole)
- Lower arm #2 or middle position
- Gold springs
- Long ball end type
i am very confused and don't have a clue how to measure anti-squat, or how to use the alum rear suspension holder "chart".