Originally Posted by
slowrider
Thank you all!
That is actually a good question. I'm Swiss, we are known for neutrality and compromises
. Seriously, I first thought, 14.8V for a 1/10 car is a lot, but like in the heli scene: more voltage is always better to lower the current and therefor the efficiency. Btw (and sorry for this newbie question)...
- What 4S lipo's do you use (capa, realistic c-rates)? What is a good weight (assumtion: HW 3656 or Tekin Pro 4HD with RX8 Gen2)? Soft- or Cardcase?
Thanks for the hint! Because of personal reasons, I do not want use Castle stuff. Very bad experience (in RC Heli). I know, its not fully adaptable to RC Car stuff and not logically explainable. I just will never have a good feeling if "Castle" is written on it - event if the Mamba stuff looks OK.
Thanks! Makes sense! I think I change my plan form a S3 to a
S4 setup. The minor problem I see regarding the motor:
- Hobbywing xerun 3656 -> lowest -> 3400kv
- Tekin suggests for 4S the 1850kv Pro4 HD motor
Now i'm a bit confused
. Is the HW xerun out of the game on 4S? Pro4 HD 1850 is a bit on the low side. +/- 2200 would be the sweet spot, right? What would YOU go with on
4S (on a Tekin ESC):
- Pro4 2400 / 15t
- Pro4 HD 2500 / 15t ()
- HW 3656/3400 / 11t
Thx a lot!
//Raphael
HW sctpro 120amp will be fine for 4s set up. I'm running HW sctpro/Tekin T8i 1950/4600 mah 4s with 18 pinion in my Tekno Sl.3 buggy. 13-15 min of run time and cool running as well.