Thanks for the tip. Might have to try those rear arms out. I am running on a med-high traction clay track(where the Spektrum/Horizon Hobby races are held). I bought the 5mm hexes to narrow the track width a bit in hopes of a little more traction so i'll have to see how the arms affect it. Amain shows that the yz-2 and yz-4 rear arms are the same from the compatibility tab, so maybe its just the Bmax rear arms. I did see on amain the 74mm arms, are you talking about those then?
http://www.amainhobbies.com/rc-cars-...008rs4/p474525
and were you talking about these -
http://www.amainhobbies.com/rc-cars-...415r00/p474568
I unfortunately waited to order these in the event the only way to make the axle fit was to use the B5m axles/hub. So will have to put them on a list since I don't want to use the stock plastic ones anyways.
Soon as the AT&T guy is out of the house I can get heading over to Trackside to pick up the other parts I need. Should have some sort of answers by 1pm cst, LMAO