Had a race last sat. on a med to high bite indoor track which is kept in pretty good condition, and is smooth. I had a setup I had got off line and had been adjusting it, as I just could not get it to turn as tight as others were, they could hug the inside corners where I had to take them outside because of lack of turning radius and a push, in the straight I can keep up with everyone else so I am losing it all in the turns. I am running the tire of choice for our track (dirt webs). After first qual. I re did the rear to the box setup with the exception of I run the brass D block. The front has 1mm spacers added under the turn buckles, and someone had told me to change the alum spacers on the steering. And I run the ride height at 28/30 and have the next lower spring on the front, stock is 3.6 I think if I remember correctly and I have the 3.3 For my next race I think I am going to go box setup on everything but the front springs I am going to leave the lighter ones on. What can I do at this point to help it turn better (tighter) it comes out of the corners nice and jumps nice its just that one point I seem to be having trouble. Also I do run some drag break does that help or not. Any suggestions is greatly appreciated in advance.