Originally Posted by
kbish76
Just received my XB2. It also came with the addition of a built ball diff. (Very cool). I have a few questions on the build.
1. What grit sandpaper do I use? 400-500
2. Will any CA glue work on the carbon fiber parts?
3. Looks like 1.6 front and 1.7 rear Piston size. But what about oil thickness?
4. I have slim stagger (yellow) do I run them with NO foams?
5. And I'm running this in stock what recommendations to ppl have?
Sorry for all the questions I really look forward to building and driving this baby!
I can help with some of these....
1. 400-500 is fine, I personally use a Dremel with a fine sand (quicker)
2. Preference, I prefer a thin CA. Apply with small Foam sponge or Q-Tip (requires quick work with thinner CA)
3. Start with what's included in the kit, adjust from there.
Enjoy!