Originally Posted by
randy0025
yes i have read page in the book like 10 tens and i still dont understand it.
I guess where I get lost is if for example, if you get the inserts that have the dots in the middle but toward the inside it say -1.5 track, well what would the Anti Squat and Roll Center and Toe In? sorry if this is a really dumb question i am normally good at this stuff but just dont get there system. thank
So, on the rear,
if both dots front and rear are inside, they narrow the track width.
If the front is inside and the rear is center, it adds toe
Now, if you have the width/toe set in mind.
the front rear hanger's are Up(higher than the rear), that will add Anti Squat.
Now, the overall pin height will change roll center.
there are many configurations, start with the book setup and change from there.