Originally Posted by
R1Joel
Took the shock back apart and took a few little notches off the plastic rings that go in the bottom of the shock and it worked. Must have been a little bit pushing the ring off centre and into the shaft. Was able to achieve rebound. The hard bit was getting the silly screws that hold the bottom of the shock into the arm. What's wrong with a normal hex screw? For that matter why did Tekno make them left and right hand threads?
Normal screws can get clogged with dirt, a hex is easier to clean off to remove. We did left and right threads because as the shock moves it tries to unthread the shock screws. If we didn't do the left hand threads on that side it would slowly unscrew.
Check your retaining nuts for the top of the shocks, I bet the side opposite the left handed bottom screw has to be re-tightened more often than the other.