I started this build last night, overall I'm really happy with the car. The quality is good, the pricing is great and you get a hell of a lot of car for your money.
A couple of pain points I've found though;
- Bell crank bearings, the sit a fraction of a mm above the bell crank arms so when you fasten down the front bulkhead the bearings bind. You need to back them off to get free play in the bearing which means the screw and bulk head are not secure.
- The mud gaurds, non of the holes line up. So you need to jig and shimmy fasten and unfasten to get them to a point where they line up.
Otherwise good car, but the bell crank bearing issue is a biggy.