Originally Posted by
BentKa
So if you pre-thread a rod end using a 3mm screw you can not get the turnbuckle to enter that rod end at all (short end being the right hand thread) ?
Have you tried a 3mm nut to see if one end is indeed a normal right hand thread ?
You have a picture of the turnbuckle ?
If it's indeed threaded is should at least have either right hand or left hand threads…..ideally one of each though
Bent
Yes i tried an m3 nut. It doesn't work but the m3 nut will work on other rod ends that does not have this problem