Originally Posted by
madweazl
Your 1/8 buggy will fit in the drawer and the 4wd buggy will as well. On another note, of the three bags I have (JConcepts, Racers Edge, and OFNA), it is my least favorite because the compartment dividers sag even with little weight making it difficult to pull the drawers below them, out. I never use this bag anymore and would look for something else.
Your 1/8 buggy will fit in the top drawer of the Racers Edge bag and a 1/10th in the middle drawer leaving the two lower smaller drawers at the bottom, the top compartment (where my batteries, chargers, and motors are) and the side pouches for parts and stands. Oh, and the back for setup station and pitmat. Far better choice for the money in my opinion.
Wish the moderator wouldnt have locked your original post as I love JConcepts other products and hate to speak ill of them but this case just isnt worth the money.
Edit: and it has wheels!
Thanks for the info. I was looking at the racers edge. You are referring to the 1/8 hauler right? I also looked at the Atomik hauler which looks to be almost the same as the Racers Edge? Only difference is there are 2 drawwers in the middle instead of one like the Racers Edge. Maybe I could just take the drawers out and slide my 10th scale in there. Just debating, cause the Atomik is like $50 cheaper than the Racers Edge and they seem to be the exact same other than the middle drawer thing. Does the racers edge have the holders for drivers in the top that is removable too?