Thread: HPI RS4 Sport 3
View Single Post
Old 11-02-2015, 07:18 AM  
Mr P!nk
Tech Adept
 
Mr P!nk's Avatar
 
Join Date: Mar 2009
Location: SC
Posts: 119
Trader Rating: 1 (100%+)
Default

If you are planning on running RPM rod ends then you will have to swap out all the stock ball studs. I believe all the stock ones are 4.7mm I put 4.3mm on my car and even those are a little to tight with the RPM rod ends. I snapped them on and off a few times to loosen them up, and I've been driving the car with them so they are finally to the point that they don't bind anymore.

Just giving you a heads up that the RPM's are not a direct replacement.
Mr P!nk is offline   Reply With Quote