Originally Posted by
tony montana
Yeah one of the caster block hinge pins is about a 1/4 inch shorter than the other. So I tried building it anyways and if I hold the assembled caster block together it simply falls out. Yeah I seen the rears are wider. And they go into the rear arms perfectly. But the front ones, are just to wide. They won't even go into the front 25 degree block. At first I was just gonna drill out the arms to fit the pins, but don't wanna drill out the 25 degree block and arms.
Ok to clarify, you're in need of 2 front inner hinge pins, 1 outer front hinge pin and a 10mm ball stud?