Originally Posted by
mel_russ615
I bought the mid conversion kit and while assembling the tranny. I found that the bearing for the top shaft won't fit in the case properly. The right side of the case isn't allowing the bearing to seat all the way in. Has anyone else had this problem? It's the four gear tranny case in case that matters
AE has updated the top shafts to the V2 version (same as the 3 gear) which uses a smaller bearing (same size as the idlers etc). The 4 gear has a new case (V2 case, different part number to the original 4 gear) so Id say they have included these cases in the conversion kit.
Ray