Originally Posted by
Casper
Oh you are using the stock servo arm. It may be a bit of a press still. The two should got on. Most of us use an alum servo arm. The stock one is fine but an alum arm flexes less.
That is odd about the bearings. I would make sure the bearings are fully seated. get the axle/ bone assy in place and hex on and then push and pull on the assembly to make sure everything is seated properly as it could be a very small alignment issue but the parts should be good.
Thanks everyone. I'll double check all the bearings tomorrow and see what I come up with. Otherwise I'll put a call in to Horizon.
What part number aluminum horn do you run? Don't see one referenced specifically for the SCTE.